80, Front Door, part 11, (the last!). Leadlights, part two.

-

In order to speed up the cutting of the pieces of glass for the borders, I set up the simple jig, seen in the above photo. It worked very simply and was able to produce very accurate cuts. When it came to the curved pieces, needed for the arc on the tops of the upper panels, the ruler was exchanged for the red bar shown. The difference in the curvature of the inner and outer radius's required was barely perceptible and the right hand side of the bar was filed to their average. The pieces only needed trimming to length and virtually no clean up of the edges was required, as I achieved an accuracy of about 0.2mm.

My soldering was far from perfect, but I was very happy with the results nonetheless. The joints looked very lumpy and obvious, but after completing the puttying and polishing, as seen on the left hand panel above, they became very inconspicuous.

The puttying was a horrible, messy job, but the results were speaking for themselves. I found that I had to wait a few days after doing the first side, before tackling the other. This was to allow the putty to harden sufficiently and prevent it from being forced back out.

Jumping back to the start of this part of the project, much deliberation was carried out when selecting the glass colours. In the above photo, I set up this mock up using pieces of glass that we already had. I felt that the overall look may turn out to be too dark and gaudy, so opted to source some paler shades for the lighter colours.

The almost completed entry!, only a bit of touching up of the paintwork on the glass beadings to be done.
As happy as I am with the finished product, with hindsight I regret the decision to lighten the colours. They looked very nice on the work bench, but when installed and with backlighting, to me they appear very wishy washy against the rondels and red borders. They are not actually as bad as they appear in this picture though, the best I have been able to take so far.